How To Set My Timex Alarm Clock

TIMEX Dual Alarm Fm Clock Radio

What'south in the Box

Controls Overview

Display

Backup Battery

Your new Timex Clock includes a built-in battery backup system that will maintain the time and alarm settings during a temporary ability interruption. Remove the battery pull tab located on the bottom of the unit. When the Low Backup Battery Icon glows on the display, it is fourth dimension to the replace the backup battery.

Go along unit connected to AC power when replacing the battery, or you will lose settings.
Use a Phillips screwdriver to open the battery backup compartment door located on the bottom of the unit.
Remove exhausted bombardment and replace with a fresh CR-2032 battery, making sure the '+' side is facing upward.
Supercede the bombardment compartment door. Do non overtighten the screw.

Product Care

A protective moving picture is attached to the front of the display. Information technology tin can be removed by peeling it off.
Place the unit on a level surface away from sources of direct sunlight or excessive heat.
Protect your article of furniture when placing your unit on a natural forest and lacquered finish. A cloth or other protective material should be placed between it and the furniture.
Stronger cleaning agents, such as Benzene, thinner or similar materials can harm the surface of the unit.

Set

Connecting to Power Source:
Connect the included Ac adapter to the DC jack located on the dorsum of the unit of measurement and connect the other stop to a working wall outlet.

Setting the Time

Press and agree the Time Ready Button.
Press and release the Minus Button (-) repeatedly to adjust the 60 minutes.Press and release the Plus Push (+) repeatedly to adjust the infinitesimal.
NOTE: The PM indicator will calorie-free on the brandish when the hr is gear up for PM. There is no AM indicator.
Printing the Time Fix Push button to ostend settings.

Setting and Using Alarms

Printing and hold Alarm One OR Warning Two. Each alarm can exist prepare in the aforementioned way.
Press and release the Minus Push (-) as needed to conform the hour.Printing and release the Plus Button (+) as needed to adjust the minute.
Press Alarm One or Alarm Two to confirm the alarm fourth dimension.
NOTE: The PM indicator will light on the display when the hour is set for PM. There is no AM indicator.
Printing and release the Minus Push button (-) or Plus Button (+) to select your wake to source: cablegram or radio. The or icon volition lite on the display to confirm your selection.
Press Alarm One or Alarm Ii to confirm settings.

Sleep Fashion

Printing the Power/Alarm Reset Button to turn on FM radio.
Press and release the Minus Button (-) or Plus Button (+) to select a radio station. (Press and hold to chop-chop scroll through the stations.)
Press the Sleep Fashion Push button repeatedly to select a sleep period between x-90 minutes, or OFF.

Wireless Charging

Supports:

Qi uniform phones (also works with plastic cases up to 3mm thick)
AirPods with wireless charging example
Place Qi compatible device face upwardly on the wireless charging pad as pictured below:

Caution:
Remove metal protective or magnetic case from phone before charging. When charging phone, practise not identify magnetic-striped or other metal objects on the charger. Doing and so could impairment the object or this unit of measurement. Qi compatible phones with metal looking finishes will charge unremarkably

Check the Wireless Charging Condition LED Indicator to monitor charging status:

Solid green LED: Device is charging.
Rapid blinking amber LED: Device is non charging properly. Reposition device.
Solid amber LED: Device fully charged.
Note: The LED indicator may proceed to glow solid greenish when iOS devices are fully charged. The LED indicator may alternate between solid light-green and flashing amber while charging AirPods.

Charging Devices via USB Port

You tin can also charge your devices via the USB port located on the back of the unit of measurement.

To charge devices:

Connect the standard size stop of a USB cable (not included) to the USB port on the back of the unit.
Connect the other cease to the charging port on your device.
(Make sure the unit is plugged into a working outlet in gild to charge devices.)

FM Radio and Presets

Press the Power/Alarm Reset Push button to plow on FM radio.
Printing and release the Minus Button (-) or Plus Button (+) to select a radio station.(Press and hold to speedily scroll through the stations.)

Brand sure the antenna is extended for best reception.
HOW TO PROGRAM FM RADIO PRESETS
Yous can store upward to 10 FM presets by following these steps:

Press the Power/Warning Reset Push button to turn on FM radio.
Press and release the Minus Button (-) or Plus Push (+) to select a radio station. (Press and hold to quickly scroll through the stations.)
Press and hold the Fourth dimension Ready/FM Presets Button. The display will flash.
Press and release the Minus Button (-) or Plus Button (+) to choose a preset position between P01-P10.
Press the Time Set/FM Presets Button again to confirm the preset station.
Echo steps ii-v to prepare up to 10 preset stations.
When listening to FM radio, repeatedly printing the Time Set/FM Presets Button to access your stored stations.

Troubleshooting

The unit of measurement does non power ON.
The unit is not connected to Air conditioning outlet, the Air-conditioning outlet has no ability, or is controlled by a wall switch that is "OFF". Check AC outlet and wall switch.
Alert does not come on.
The alarm time AM or PM incorrectly set, Alarm was OFF, etc. Bank check alert settings.
Unit of measurement shuts "Off" unexpectedly.
a. A power surge has occurred, or the Ac outlet has been disconnected.
b. The Ac outlet may be controlled past a wall switch that is turned OFF. Bank check Ac outlet or wall switch.

IMPORTANT SAFETY INSTRUCTIONS

Please heed all warnings, read and follow all instructions and continue these instructions handy for time to come reference.

Exercise not utilize this product almost h2o, and make clean only with dry cloth.
Do non block whatever ventilation openings. Install in accordance with the manufacturer'due south instructions.
Heat – This product should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat.
Only use attachments/accessories specified by the manufacturer.
Unplug this production during lightning storms or when unused for long periods of fourth dimension.
Impairment Requiring Service – This product should be serviced by qualified service personnel when:
- Plug has been damaged.
- Objects have fallen into or liquid has been spilled into the enclosure.
- The unit has been exposed to rain. The unit has been dropped or the enclosure damaged.
- The unit exhibits a marked modify in operation or does non operate commonly.
No naked flame sources, such as lighted candles, should be placed on this product.
Attention should be drawn to the environmental aspects of battery disposal.
This product is suitable for use in tropical and/or moderate climates.
WARNING: To reduce the risk of fire or electrical shock, do non betrayal this product to pelting or moisture.
Do not dispose of batteries in the household trash or fire.
The mains plug of power adaptor is used as the disconnect device, it shall remain readily operable.

Alert:

Exercise non ingest the battery, Chemical Burn Risk. This product contains a coin/button cell battery. If the money/button cell bombardment is swallowed, it can cause severe internal burns in just ii hours and can lead to death.
Keep new and used batteries away from children. If the battery compartment does not close deeply, cease using the product and keep it away from children. If yous remember batteries might have been swallowed or placed inside any office of the torso, seek firsthand medical attending."
Circumspection – Take a chance OF EXPLOSION IF BATTERY IS REPLACED By AN INCORRECT Blazon. DISPOSE OF USED BATTERIES Co-ordinate TO THE INSTRUCTIONS.

FCC Information

This equipment complies with FCC RF radiations exposure limits prepare forth for an uncontrolled environment.
This device complies with Function xv of the FCC Rules, operation is subject to the following two conditions:

This device may not crusade harmful interference, and (two) this device must accept any interference received, including interference that may cause undesired operation.

Alert: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user'southward authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and tin radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which tin be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a excursion different from that to which the receiver is continued.
Consult the dealer or an experienced radio/TV technician for assist.

This equipment should be installed and operated with minimum altitude 20cm between the radiator & your body.

IC Statement

This equipment complies with IC RSS-102 radiation exposure limits gear up along for an uncontrolled environs.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s).
Operation is subject to the following 2 conditions:

This device may not cause interference.
This device must accept any interference, including interference that may crusade undesired operation of the device.

The device comply with ISEDC RF exposure requirement, users tin can obtain Canadian information on RF exposure and compliance.

This equipment should be installed and operated with a minimum altitude of 20 cm between the radiator and your body. Any Changes or modifications non expressly approved past the party responsible for compliance could void the user's authority to operate the equipment.

Limited 90 Day Warranty Information

Timex Audio Products, a division of SDI Technologies Inc. (hereafter referred to as SDI), warrants this product to be complimentary from defects in workmanship and materials, under normal use and conditions, for a period of ninety (90) days from the date of original purchase.

Should this production neglect to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this fail to resolve the thing and service still be required by reason of any defect or malfunction during the warranty catamenia, SDI will repair or, at its discretion, supercede this product without accuse. This decision is subject field to verification of the defect or malfunction upon delivery of this product to the Manufacturing plant Service Centre authorized by Client Service.

If service is required, please visit timexaudio.com/back up for more than information. A copy of the sales receipt is required to validate in-warranty coverage.
Disclaimer of Warranty

NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover

products which have been damaged by negligence or willful actions, misuse or accident, or which have been modified or repaired past unauthorized persons;
cracked or broken cabinets, or units damaged by excessive oestrus;
harm to digital media players, CD's or tape cassettes (if applicable);
the cost of aircraft this production to the Manufacturing plant Service Center and its render to the owner.

Ezoic

This warranty is valid only in the U.s.a. of America and does not extend to owners of the production other than to the original purchaser. In no event will SDI or any of its affiliates, contractors, resellers, their officers, directors,shareholders, members or agents be liable to y'all or whatever 3rd party for any consequential or incidental damages, any lost profits, actual, exemplary or punitive damages. (Some states do non allow limitations on implied warranties or exclusion of consequential damages, so these restrictions may non use to you.) This warranty gives yous specific legal rights, and you may also have other rights which vary from land to state. Your acknowledgment and understanding to fully and completely abide by the above mentioned disclaimer of warranty is contractually bounden to you upon your transfer of currency (money order, cashier's check, or credit menu) for buy of your SDI production.
© 2022 SDI Technologies, Inc. All rights reserved
Questions? Visit www.timexaudio.com
TIMEX is a registered trademark of Timex Corporation in the U.s. and other countries

Documents / Resources

References

Source: https://manuals.plus/timex/dual-alarm-fm-clock-radio-manual